LCD Projector Lamps Online Store Selection » steps http://lcd-projector-bulbs.com Save on Replacement bulbs for LCD and DLP projectors Sun, 12 Jul 2009 18:13:05 +0000 http://wordpress.org/?v=2.9 en hourly 1 Steps To Replace A Projector Lamp http://lcd-projector-bulbs.com/steps-to-replace-a-projector-lamp/27 http://lcd-projector-bulbs.com/steps-to-replace-a-projector-lamp/27#comments Fri, 18 Apr 2008 15:24:48 +0000 lj772 http://lcd-projector-bulbs.com/steps-to-replace-a-projector-lamp/27 If you have a it is obvious that the may need replacement. Any time your may start flashing light, then its time to the .These are some simple to the so that you can enjoy your or TV without interruption.

Step 1

Make sure that the is switched off. Then remove the power cord from the unit completely.

Step 2

Remove the panel using screwdriver. Make sure that you do not damage the . It’s better to use Micro fiber cleaning cloth.

Step 3

Open the section door. It’s located underneath the unit whereas in rear Projection TVs, the section should be located in the rear towards the bottom left or right side of the TV. 2-4 screws will be holding the section in place. Remove the 2-4 screws which hold the section and the section door.

Step 4

Remove and pull up the assembly. Then make sure that you do not get confused with the new and the old .

Step 5

When is open there are chances of getting dust. Have a micro fiber cloth beside you.

Step 6

Insert the new with out changing the orientation and reconnect the cables.

Step 7

the section door back into the place and carefully screw without screwing it tightly.

Note:

Always have a backup in case the light go out unexpectedly.

Source Article: http://www.ehow.com/video_2203640_replace--.html

Tags: , , , ,
]]> http://lcd-projector-bulbs.com/steps-to-replace-a-projector-lamp/27/feed 2